I tried to connect point to point on CIMC but It doesn't give any dhcp or even a notification that my laptop is connected to a network but working on my console. I tried to connect point to point on CIMC but It doesn't give any dhcp or even a notification that my laptop is connected to a network but working on my console (Cisco Controller-Standby) >show imm chassis sol-info RISER2_OUTLETTMP | D6h | ok | 7.4 | 29 degrees C RISER2_INLET_TMP | D5h | ok | 7.3 | 25 degrees C RISER1_OUTLETTMP | D4h | ok | 7.2 | 27 degrees C RISER1_INLET_TMP | D3h | ok | 7.9 | 27 degrees C PCH_TEMP_SENS | B3h | ok | 7.0 | 28 degrees C PSU1_TEMP | B1h | ok | 10.1 | 20 degrees C P1_TEMP_SENS | 8Eh | ok | 3.1 | 33.50 degrees C Switch (bottom) BayStack 5520 Switch benefits Power to IP phones, wireless access points, network cameras, security and lighting devices, and access control devices Provides power on all ports IEEE 802. PSU2_PWRGD | 2Eh | ns | 10.2 | No Reading Im trying to create a static route on a Baystack 5510 Ethernet Routing Switch with the following: ip route 192.168.104.220 255.255.255.255 192.168.100. PSU2_AC_OK | 2Dh | ns | 10.2 | No Reading Baystack 5520 serial port settings download#ASCII configuration file BayStack 5520 Switches can download a user. (Cisco Controller-Standby) >show imm chassis power-supply The NNCLI is used through a Telnet session or through the serial port on the console. (Cisco Controller-Standby) >show imm chassis memory (Cisco Controller-Standby) >show imm chassis mac (Cisco Controller-Standby) >show imm chassis fan-profile Temperature Fetch Chassis Temperature information Baystack 5520 serial port settings how to#How to Reset Nortel 5520 Switch and access it through console. Sol-info Fetch Serial Over Lan information Baystack 5520 Serial Port Settings Some newer switches allow setting up a matrix (with rows and columns for each port) to specify from/to which ports traffic can be forwarded, others allow. Power-supply Fetch Chassis Power Supply information Avaya bought all of Nortel's IP to do with voice and data. If you want support, you may be able to obtain this from Avaya, at a significant cost. We have run Nortel switches at one of our locations for the past 10 years. (Cisco Controller-Standby) >show imm chassis ?Ĭurrent Fetch Chassis Current informationįan-profile Fetch Chassis FAN power profile The 5520 is quite loud - fine in a data center, probably too loud for home. (Cisco Controller-Standby) >show imm chassis fan (Cisco Controller-Standby) >show imm chassis current This is the output of show commands got from the CIMC port. Re: WLC 5520 Standby system status amber light blinking
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |